2.2 Class Bodiless???

[Silas]

I was just reading the 2008 rules and it has some specs to a 2.2 bodiless rig. Does the edge not fall into this?

[Silas]

Well after discussing with a few folks, it seems that it just might. Before, tubers and non body rigs would fall under the Super class, so it seems now there is a place for tubers in 2.2 now... sweet!!!

[Ruthless Racer]

Good to know My edge is legal:D

[Threadlocker]

Good to know My edge is legal:D

I know it is.. I built it:hihi: The new one I just built is too..they must have panels on the sides and top from what I understand

Steve-O

[Silas]

2.1.3.1 - Bodiless vehicles must have solid hood panel, solid roof panel and a minimum of 2
solid side-panels. Hood, roof and side panels must be separate pieces of solid material
installed onto the bodiless vehicle frame. All body panels are to be separate pieces from the
complete structural frame. Body panels must be solidly installed in a manner that is
representative of a 1:1 vehicle. It is required that at least one point of the side-panel must
reach to a span of 1” tall or more & at least one other point of the side-panel must reach to a
span of 2.5” long or more. In the case of a Unibody vehicle (See sec. 2.1.3.2 for Unibody
definition). The Unibody is considered to have all body panels needed without having to add
separate body panels as long as the hood, roof & side panel areas meet all the general panel &
side-panel size requirements above.

Yup as well as a hood.

[Threadlocker]

correct!

[renoirbud]

Tuber have always been 2.2 legal.

The issue was that you could not add tubing to a TVP chassis and call it a tuber. But now you can and the edge is legal.

[Silas]

oh...ok... I just thought bodiless was what wasn't allowed... cool.