Vanquish Wheel Hub and foam input needed

[peterh]

I can get a pretty good deal on some wheels, knuckles etc. But I will need foams and hubs to get her going. What are your reccomendations? I also added a picure of the tires that came with my XR10 that I plan on running.

Hub sizes for the SLW's (rear) are Axial Measurements
225 = 8.55, 350 = 8.80, 475 = 8.92, 600 = 9.05, 725 = 9.3

Hub sizes for the DHII (Front) are Axial XR-10 Axle
335= front n/a / Rear 8.90
460= front 9.95 / Rear 9.15
585= front 10.2 / Rear 9.40


Axial AX-10 Axle
335= 8.37 rear only
460= 8.62
585= 8.87




Vanquish XR-10 DH 2s up front with (6) .38 caliber weights and (6) standard weights. Red rings on front and rear rims. Rears are SLWs (these were used but lightly --not with the res rings tho..they are new).

[CRSMacgyver]

I would run 460s in the front on DHIIs and 475 or 600s in the rear on the SLWs.

What kind of tires are you setting the foams up for?
I would contact Eddie at Crawler Innovations for some recommendations.

For Sedonas or Rovers I would look at 5.5" DD Foams
Front: Medium or Firm Inner, Soft Outer
Rear: Medium or Firm Inner, Medium Outer
Add in some tuning rings so you can dial it in.

[peterh]

Andy,
Thanks I spoke with Eddie and have a set of foams comming to me.

Does anyone outhter have a set of Vanquish Hubs that they want to part with?

[untchabl]

I have some hubs, let me see what widths I have and I'll let you know.

I know I don't have any spare 460's though.